Robotic inspection

Robot-loaded bearing gauge system

An automated final inspection system checking radial and axial clearance and key dimensions on spherical plain bearing assemblies.

SCARArobot loaded
2clearance stations
Closed-loopforce control
Robot-loaded bearing gauge system

How it works

  1. 01Bearings are loaded onto an input conveyor that indexes until a part is detected in one of three vee locations.
  2. 02A Toshiba SCARA robot loads the part onto a nest on the CMM for dimensional checks.
  3. 03The robot moves parts from the CMM to STT’s bespoke clearance checker, then to the pass or fail side of the output conveyor.
  4. 04Pneumatic pick and place units move the part between the axial and radial stations.
  5. 05The inner ball is pushed both ways and clearance measured from two linear transducers, with force controlled in closed loop by an electronic regulator and load cell.

Built with

  • RobotToshiba SCARA
  • MeasurementBaty CMM + STT clearance checker
  • ControlSTT system: robot, CMM, PLC and PC software

Need something like this for your line?

Start a project